Table of Contents
Advertisement
[VIDEO Input Signal]
Problems
1.
No Picture
• Power indicator does not light up.
• Power indicator lights in orange.
• Power indicator lights in blue.
2.
The message below appears.
• The frequency of the signal is outside the specification.
Example:
3.
The color shown on the display is not correct.
4.
The video images are out of control by the FF/REW
operation when a video equipment is connected to
the monitor.
5.
No sound/Volume control is not available.
Possible cause and remedy
• Check whether the power cord is correctly connected.
• Touch
.
• Switch the input signal with
• Turn on the AV equipment.
• Check whether the AV equipment is properly connected
to the monitor.
[For VIDEO 1/VIDEO 2 input signal]
• Switch the setting using the <Field Rate> in the <Monitor
Settings>.
These messages appear when the input signal is incorrect
even if the monitor is functioning.
[For VIDEO 1/VIDEO 2 input signal]
• Confirm the digital signal format by referring to the
instruction manual of the equipment connected. (Refer to
page
42.)
[For VIDEO 1/VIDEO 2 input signal]
• Change the color space of the video input signal using
<Color Space> in the <Monitor Settings> menu.
(Normally, select "Auto".)
• The monitor mechanism causes the image out of control
status a little. This is not a malfunction.
[For VIDEO 1/VIDEO 2 input signal]
• Check whether the applicable format of the equipment
connected is correct.
Refer to
page 42
for the sound input format of the
monitor.
Chapter 4 Troubleshooting
.
3
Advertisement
Table of Contents
