DeLonghi ECAM51 55 Series Instructions For Use Manual page 28

PROBLEM
At the end of descaling, the
appliance requests a third
rinse
The milk does not come out of
the milk spout (D5)
The milk contains large
bubbles and squirts out of
the milk spout (D5) or there is
little froth
The cup warmer is hot, even
though it has been disabled
The machine emits noises or
small puffs of steam while not
in use
POSSIBLE CAUSE
During the two rinse cycles, the water tank
(A18) has not been filled to the MAX level.
The lid (D2) of the milk container lid is dirty
The milk is not cold enough or is not semi-
skimmed or skimmed
The froth adjustment dial (D1) is incorrectly
adjusted.
The milk container lid (D2) or froth adjustment
dial (D1) is dirty
The hot water connection nozzle (A15) is dirty Clean the connection nozzle as described in
A number of beverages have been prepared in
succession
The machine is ready for use, or has recently
been turned off, and condensate is dripping
into the hot vaporiser
REMEDY
Follow the instructions displayed by the appli-
ance, but first empty the drip tray (A24) to avoid
the water overflowing.
Clean the milk container lid as described in sec-
tion "4.3 Cleaning the milk container".
Use skimmed or semi-skimmed milk at refrig-
erator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
Adjust following the instructions in section
"8.1 Adjusting the amount of froth".
Clean the milk container lid and froth adjust-
ment dial as described in section "4.3 Cleaning
the milk container".
section "9.1 Cleaning the hot water nozzle".
This is part of normal operation. To limit the
phenomenon, empty the drip tray.
27