Medalist 17242, 13032, 10232, 8422 and 4312, Rev. A
Additional installation options
Figure 5. Non-ATA compatible and cable select jumpers
Non-ATA compatible slave jumper
If your computer does not recognize your new drive as a master
in a two-drive system, the slave drive may not be ATA-compati-
ble. You may be able to solve this problem by installing jumpers
on pins 5 and 6 and on pins 7 and 8, as shown in Figure 5.
Cable select jumper
Some computers differentiate between master and slave drives
using specially designed interface cables that have the line to pin
28 (the Cable Select pin) removed or cut at one connector. The
connector that has pin 28 disabled is used for the slave drive.
See your computer manual to determine whether your computer
supports this feature. To configure your Seagate drive for cable
select, place a jumper as shown on pins 5 and 6.
2 4 6
8
1 3 5
7
Master with non-ATA
compatible slave
Enable cable select
19