Medalist 1721, 1010, Rev. B
Additional installation options
Figure 5. Non-ATA compatible and cable select jumpers
Non-ATA compatible slave jumper
If your computer does not recognize your new drive as a master
in a two-drive system, the slave drive may not be ATA-compati-
ble. You may be able to solve this problem by installing jumpers
on pins 3 and 4 and on pins 5 and 6, as shown in Figure 5.
ATA interface
connector
2 4 6
4-pin power
connector
1 3 5
Master with non-ATA
compatible slave
Enable cable select
17