Citizen CT-S4000DC User Manual page 36

Metal frame
Label paper sensor
adjuster *L
1 Enter Adjusting Paper Sensor mode.
Open the printer cover, remove paper, and then set the printer power switch
to ON. Here, POWER LED and ERROR LED go on with the buzzer sound.
Then close the printer cover while pressing the FEED button. The ERROR
LED starts blinking with the buzzer sound.
2 Set Paper to be adjusted to the Printer.
This printer has three types of built-in paper sensors.
In case of label, set it so that label is positioned on the label light receiving
sensor and label light emitting sensor. In case of Black Mark paper, set it so
that the printable portion (other than black mark) is positioned on the Black
Mark sensor. With this state kept, closing the printer cover causes ERROR
LED to blink with the buzzer sound.
3 Adjust Paper Sensor.
Turn the corresponding adjuster counterclockwise by using a tapered flat
screwdriver. Set the adjuster at the position where LED begins to change
from orange to green.
Turning the adjuster
counterclockwise
* While turning the adjuster by the screwdriver, do not let the part of the
screwdriver touch the metal frame. Otherwise proper LED light color
will not be displayed while touching.
4 Perform Paper Measuring operation
When the FEED button is pressed, label is fed and paper measuring is carried.If
the FEED button is presed during the paper measuring, the result will be
printed out as follows, and the printer memory switch will be initialized.
* The measuring result is a reference value
showing a gap between labels
Label Length
Gap Length
< Example of label measuring result*L >
Level indicator
LED
Black Mark paper
sensor adjuster
Green
showing a label length
: XXXmm
: XXmm
Black Mark sensor
Orange
showing a black mark pitch
showing a black mark height
Black mark Interval
Black mark Length
< Example of black mark paper measuring result *M>
— 33 —
Label light receiving
sensor *L
Label light emitting sensor *L
Red
: XXXmm
: XXmm