Chevrolet Silverado 4500HD 2022 Owner's Manual page 57

Example Rear Driver Side Position
Example Rear Driver Side Position
2.1. For a top tether in the rear driver
side position:
2.1.1. Raise the headrest.
2.1.2. Route the top tether (4)
between the headrest posts,
through the loop (3), behind
the inboard headrest post,
and under the center
shoulder belt (2).
2.1.3. Then attach the top
tether (4) to the top tether
anchor (loop) (1) at the center
rear seating position.
2.2. For a top tether in the rear center
position:
2.2.1. Route the top tether (4)
through the center loop (1),
and behind the passenger
side headrest post.
2.2.2. Then attach the top
tether (4) to the top tether
anchor (loop) at the rear
passenger side seating
position.
2.3. For a top tether in the rear
passenger side position:
2.3.1. Raise the headrest.
Seats and Restraints
2.3.2. Route the top tether (4)
between the headrest posts,
through the loop on the
passenger side, and behind
the inboard headrest post.
2.3.3. Then attach the top
tether (4) to the top tether
anchor (loop) (1) at the center
rear seating position.
3. Tighten the top tether per the child
restraint manufacturer's instructions.
When the top tether is properly
tightened, the anchor (loop) may bend.
This is normal and will not damage the
vehicle.
If child restraints are installed in both
outboard positions, both top tethers can
be attached to the center loop. Top
tethers can be attached for child
restraints in all three rear seating
positions at the same time, following the
routing instructions above.
4. Before placing a child in the child
restraint, make sure it is securely held in
place. To check, grasp the child restraint
at the LATCH path and attempt to move
it side to side and back and forth. There
should be no more than 2.5 cm (1 in) of
movement for proper installation.
55