Table of Contents
Advertisement
User manual
20
9.7 Starting a program
To start the program:
• Touch the Start/Pause button.
• The appliance starts and the LED above the button stops flashing and stays on.
fig.X02215
9.8 Program change
To change a program:
1. Push the ON/OFF button to turn the appliance off.
2. Push the ON/OFF button again to turn on the appliance.
3. Set a new program.
9.9 Program end
Clean the filter and drain the water container after each drying cycle.
If the drying cycle is completed, the symbol
flashes on the display and the acoustic signal sounds intermittently
for 1 minute.
If you do not turn off the appliance, the crease guard phase starts. Laundry can be removed during this phase.
To remove the laundry:
1. Push the ON/OFF button for 2 seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Advertisement
Table of Contents
