Table of Contents
Advertisement
Error condition list
If occurs, try to turn Off the machine, wait for a few
seconds, then turn ON again. If the error remains, a
maintenance is required. Please contact the nearest
technical service center or Lincoln Electric and report the
LED Status found on the machine Front Panel.
On
This occurs if after 4seconds the Pilot Arc
isn't transfered to the workpiece. The
machine stops the pilot arc to avoid
overheating on the Torch Head.
Head Torch
To restore the machine:
Release the Torch Trigger pushbutton.
The
permanently ON
Press again the release the Torch
Trigger pushbutton.
On
The Torch Trigger pushbutton is pressed.
During this period the machine try to start
the pilot arc for 4 times. If the pilot arc
doesn't start the machine automatically
goes in a safe condition that allow to
check as necessary.
No pilot arc
estabilished
To restore the machine:
Turn OFF the Power switch.
Check the correct placement of the
Torch Head consumables and parts.
Check
connections.
Turn ON again the machine.
On
This occurs if the machine is switched ON
(or if it restart after cooling time) with the
Torch Trigger pushbutton hold. This status
avoids
unsafe
manual cutting or gouging processes must
be started ONLY under the direct control
of the operator.
Trigger
To restore the machine:
Pushed
Release
pushbutton.
Press
pushbutton.
If this error condition persist check for
eventual malfunctions of the the Torch
Trigger pushbutton.
English
Blink
Blink
blinking
LEDs
are
On
On
the
Torch
electrical
On
On
On
operating
conditions:
the
Torch
Trigger
again
the
Torch
Trigger
Rear Panel Controls and Connections
A.
Fan: This machine has
a
F.A.N.
Needed)
inside:
the
automatically
ON
or
feature reduces the
amount of dirt which
can be drawn inside
the
machine
reduces
consumption.
the machine is turned
ON the fan will turn
ON.
The
continue
whenever the torch trigger pushbutton is pressed. If
now
the torch trigger pushbutton is released for more than
five minutes, the fan will turn OFF.
B.
Power Switch: It turns ON / OFF the input power to
the machine.
C. Input cable: Connect it to the mains.
D. Gas Inlet: Connect here the hose carrying the gas to
the machine.
A clean, dry primary gas (air or nitrogen) must be supplied
to the machine. A pressure setting above 7,5bar could
damage the torch. Failure to observe these precautions
could result in excessive operating temperatures or
damage to the torch.
9
(Fan
As
circuitry
fan
is
turned
OFF.
This
and
power
When
fan
will
to
run
WARNING
English
Advertisement
Table of Contents
