Parameters; Parameters Pmod2; Dca1 - Peavey DPM V3 Owner's Manual

Level (00-99) =
Selects the waveform level. Lower values are softer, higher values are louder. =i
Page 2 Parameters =
Coarse (-24 to +24 semitones)
Adjusts oscillator 1's frequency in semitone steps, from -24 (transposed down two oc-
taves) to +24 (transposed up two octaves). EN
Fine (-99 to +99 cents)
Adjusts oscillator 1's frequency in cents, from -99 (transposed down 99/100 of a
semitone) to +99 (transposed up 99/100 of a semitone).
Page 3 Parameters
PMod1 (Off, Velocity, Keyboard, Pressure, Envelopes 1-4, LFO 1, LFO 2, Mod Wheel,
Foot Pedal, External MIDI Control) ,*
*
Chooses the pitch modulation source. For details on modulation sources, see sections
3.1d and 3.8.
Amount (-99 to +99)
Sets the modulation degree and polarity (positive or negative) from the previously-
selected source.
Note: You can set the keyboard to non-transpose mode (i.e., the same note is played
on any keyboard key). This is handy for some sound effects applications. To do this,
set PMod1 to Keyboard and Amount to -99. All other modulation should be off. It is
also possible to set alternate tuning scales; see Chapter 6 on Advanced Applications
for further information.
Page 4 Parameters
PMod 2 Amount
These parameters perform the same functions as PMod1 and its associated Amount
control. Thus, oscillator 1's pitch can be modified by two different modulation sources.
3.5 DCA1
The DCA module has two pages.
Page 1 Parameters
LMod1 (Off, Velocity, Keyboard, Pressure, Envelopes 1-4, LFO 1, LFO 2, Mod Wheel,
Foot Pedal, External MID! Control)
3.10