Save A Modified Program; Change Program Name - Peavey DPM V3 Owner's Manual

4. Select the parameter value.
Important: Any changes you make must be saved to the current program or a dif-
ferent one. Selecting a different program without saving the program you modified will
cancel any edits you made.
2.3a Save a Modified Program
1. After modifying the program, make sure that no parameters are flashing.
2. Press the Up Arrow key (or do a couple turns of the data knob) until you reach
the very last (Save to) page of the Edit menu.
3. If you want to save to the program you just modified, press the Exec button.
Note the [EXEC] in the display's upper right corner, indicating that you must
press Exec to finalize the saving process.
4. To save to a different program number, press the Right Arrow key. The program
number will flash.
. Select the program number where you want to store the modified sound.
. Press the Exec button. S
Note: If the display says MEMORY Protected, memory protection must be
turned off before you can save. Refer to section 2.1d for more information on
the memory protect function.
Oo
2.3b Change Program Name
Renaming is handy to identify modified programs or ones you've created from
scratch.
. Press the Prog master button and select the desired program.
. Press the Edit master button.
. Press the Right Arrow button. The first character will flash.
. Select the new character.
. Press the Right Arrow button to select the next character to be changed.
. Select the new character.
. Repeat steps 5 and 6 until the name is complete.
. Save the program if your other program edits are done.
Note: Characters available for naming are (in order of appearance as you turn the
Data knob clockwise):
ONO WD —
Upper & lower case alphabet % ]
Space (blank) $ | (vertical line)
0-9 # ' (single quote
+ @ symbol)
- » (right arrow) ;
) { /
* } , (comma)
& [ . (period)
A
2.7