Initialize Program Change Map; Midi Bülk Dump Ig - Peavey DPM V3 Owner's Manual

2. When OFF, there is a one-to-one correspondance between program changes
and the DPM V3 programs. To create a program change map, press the Right
or Left Arrow until the OFF parameter flashes.
3. Select the incoming MIDI program number with the Data knob or Up Arrow but-
ton. The left-most program number parameter will flash; this is the incoming
MIDI program number,
4. Press the Right Arrow again until the right-most program number parameter
flashes. This is the DPM V3's target program to which the incoming program
change will be assigned.
5. Select the target program to which the incoming program number will be map-
ped.
6. Repeat steps 2-5 until the program change map is complete.
2.2e Initialize Program Change.Map
To cancel all Program Change Map, assignments and start over from scratch (i.e.,
the Program Change Map will show a one-to-one correspondance between pro-
gram changes generated by your master keyboard and the DPM V3), follow steps
1-3 in the previous section but scroll all the way past incoming program 127. The
display says MIDI Prog Change Map [EXEC] to Init. Press Exec, and the Map will
be initialized, as confirmed by the display saying Function Complete.
2.2f MIDI Bulk Dump
Although the DPM V3's memory is non-volatile (i.e., it is battery-backed up to pre-
vent loss of data while the unit is turned off), accidents can happen, from a battery
going bad to operator error (Ooops! Didn't mean to
load the cartridge data into Bank 1 after all.). As a result, it's a good idea to save
your data periodically.
You may also become sufficiently seduced by the DPM V3's programming options
to make up sets of your own sounds. These should also be saved.
Although cartridges are a convenient storage medium, they are not cheap. Many
MIDI sequencers and keyboards can record System Exclusive data for storage;
playing this data back into the DPM V3 will restore the programs you saved.
To save data via MIDI:
1. Connect a MIDI cable from the DPM V3's MIDI out to the MIDI system exclusive
storage device's MIDI in.
2. Set up your MIDI system exclusive storage device to record system exclusive
data. Refer to the product's manual for how to do this.
. Select the DPM V3's MIDI Bulk Dump page.
4. Press the Right or Left Arrow button until the bottom line flashes.
5. Select the type of data to be saved:
wm
2.5