Change Overall Timbre ("Brighter/Duller"); Increase/Decrease Timbre "Dynamics; Change Program Volume Level; Change Stereo Pan - Peavey DPM V3 Owner's Manual

Hide thumbs Also See for DPM V3:

Table of Contents

2.3c Change Overall Timbre (''Brighter/Duller'')

Although there are many ways to change timbre in the DPM V3, the following

method is fast and takes care of many situations where you want to modify timbre.

1. Assuming you're in the Edit menu, select the FILTER Cutoff/Res page.

2. Press the Right Arrow button. The Cutoff parameter will flash.

3. Increase the value for a brighter sound; decrease for a duller sound.

2.3d Increase/Decrease Timbre ''Dynamics''

Sometimes the timbre responds dynamically over time, perhaps according to

keyboard velocity or to the DPM V3's internal envelope generators. The DPM V3 of-

3. Press the Left Arrow button to select the modulation amount.

. Select the FILTER FMod2/Amount page.

. If the FMod2 parameter is set to anything other than OFF, then it is being

modulated by some option. If it is OFF, then you'll need to get into some more

advanced programming techniques to modify the timbre "dynamics."

8. Press the Left Arrow button to select the modulation amount.

9. Increase the value for a wider range of timbre variations, and decrease the

value for a narrower range of timbre variations.

2.3e Change Program Volume Level

This changes a program's level relative to the other programs.

1. Assuming you're in the Edit menu, select the OUT Vol/Pan/Bend page.

2. Press the Right Arrow button until the volume parameter flashes.

3. Select the desired volume.

2.3f Change Stereo Pan

2.8

Table of Contents