Lenovo ThinkEdge SE350 V2 System Configuration Manual page 34

Figure 12. System-board switches
Table 9. System-board switches
Switch block (SW1)
1
Important:
1. Before changing any switch settings or moving any jumpers, make sure to turn off the server; then,
disconnect all power cords and external cables. Review the following information:
•
https://pubs.lenovo.com/safety_documentation/
• "Installation Guidelines", "Handling static sensitive devices", and "Power off the server " in User
Guide or Hardware Maintenance Guide.
2. Any system-board switch or jumper block that is not shown in the illustrations in this document are
reserved.
The following table describes the switches on the system board.
Table 10. System-board switches
Switches Switch
block number
1
2
SW1
3
4
5
ThinkEdge SE350 V2 System Configuration Guide
26
Switch name
XCC boot backup The node will boot by using a
backup of the XCC firmware
CMOS clear Clears the real-time clock (RTC)
registry
Password override Overrides the power-on password
MFG mode Enables MFG mode of firmware
(uEFI/XCC/FPGA)
XCC COM port Enables XCC to the serial port
Switch block (SW18)
2
Usage description
On
Normal (default)
Normal (default)
Normal (default)
Normal (default)
Normal (default)
Off