Volvo Penta 4.3GL Instruction Book page 23

1 Control lever
2
Control button (2) in the control lever is used to raise the bow,
by pressing the top half, and to lower the bow by pressing the
lower half of the button.
To put the drive in the "Beach" position, you have to press a se-
parate switch to bypass the catch which prevents entry to the
"Beach" area. This switch is on the instrument panel.
Note! The switch does not have any function if the drive does
not have a trim limiter.
Control with catch button
There is a tumbler switch (3) on the control lever to trim the
drive. By pressing the tumbler switch upwards, the drive is trim-
med out and the bow is raised. When the switch is pressed
down, the drive is trimmed in and the bow is lowered. Button (4)
is used to bypass the catch which prevents entry to the "Beach"
area.
Note! The catch button does not have any function if the drive
does not have a trim limiter.
Controls with catch button, twin installation
There are two tumbler switches (3) on the port control lever for
individual adjustment of drive trim. By pressing the tumbler swit-
ches upwards, the drives are trimmed out and the bow is rai-
sed. When the switches are pressed down, the drives are trim-
med in and the bow is lowered. Buttons (4) are used to bypass
the catch which prevents entry to the "Beach" area for each
drive and make it possible to adjust the trim in this area.
Note! The catch button does not have any function if the drive
does not have a trim limiter.
21