Side-Discharging The Clippings - Toro TurfMaster 22235 Operator's Manual

Side-Discharging the Clippings

Use the side discharge for cutting very tall grass.
Installing the Side-Discharge Chute
Important:
Ensure that the rear-discharge plug is in place before you recycle the clippings.
1. Shut off the engine and wait for all moving parts to stop.
2. Remove the grass bag if it is installed on the machine; refer to
3. Insert the rear-discharge plug (A of
4. Remove the side-discharge deflector by pulling up on the spring that holds the deflector in place and
removing the deflector (B and C of
5. Install the side-discharge chute by pulling up on the spring, placing the chute over the opening, and
lowering the spring over the tabs on top of the discharge chute (D and E of
Removing the Side-Discharge Chute
To remove the side-discharge chute, reverse the steps in
Figure 22).
Figure 22).
Figure 22
Installing the Side-Discharge Chute (page
20
Removing the Grass Bag (page
Figure 22).
19).
g235903
20).