Sony SLV-788HF Operating Instructions Manual page 9

Use this hookup if your TV has the S-Link™ function
VCR Stereo receiver
AUDIO VIDEO
@©OE tine-1 in
@e@
AUX IN
Oo" @@@ encour PP
a
2
a
3
.
Audio/video cable (supplied) Audio cable (not supplied) #
a
2.
Note
¢ To play a tape in stereo, you must use the A/V connection.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
continued
Getting Started | 9