Advertisement
KR-V6090/KR-VS090 [En]
\bout the system control connections
sontrol operations.
There are two KENWOOD system control modes. Make connections according to the groups of terminal symbols shown beiow.
(XS8! Mode:
lets you combine (XU, (XS), and X88 terminals
(SLIG) Mode: for (GLTIG) terminals only
This unit is compatible with both [XS8] and {SL16] modes. It comes from the factory set to the [SL16] mode. To switch to the [XS8] mode,
follow the instructions in "SWITCHING BETWEEN [XS8] AND [SL16]" below.
EXAMPLE: [XS8] mode connections
EXAMPLE:
[SL16] mode connections
The underlined portion represents the setting of the system
The underlined portion represents the setting of the system
control mode.
control mode.
Turntable
Turntable
{SL16] [X$8]
Receiver
[SL16] [X$8]
System
System
{SL16]
MD Recorder
control cord
[SL16]
MD: Recorder:
control
cord
LD Player
CD Player
CD Player
e Some CD players and cassette decks are not compatible with the [SL16] system control mode. Be sure to use the [XS8] system control mode when
making system connections with equipment that is not [SL16] compatible.
# Some MD players are not system control compatible. You cannot make system control connections to this kind of equipment.
LD Player
[SL16] [XS] [XS8] [XR]
[SL16] [XS] [XS8] [XR]
[SL16] [XS] [XS8]
[SL16] [XS] [XS8]
equipment consists of this kind of combination, please do not connect any system control cords. Even
without system control cords, normal operations can be carried out without affecting performance.
2. Do not connect system control cords to any components other than those specified by KENWOOD. It may
cause a malfunction and damage your equipment.
3. Be sure the system control plugs are inserted all the way in to the system control terminals.
as
1. [SL16] equipment cannot be combined with [XR], [XS], and [XS8] equipment for system operations. If your
Notes
ABOUT THE SYSTEM CONTROL OPERATIONS |
Remote Control (possible when the system control mode
[ |
matches)
:
Lets you operate source components
with the system remote
supplied with this unit.
SWITCHING BETWEEN [XS8] AND [SL16]
The system control mode can be switched over easily with the
following operation.
@ Ensure that the MAIN POWER switch on the main unit is OFF.
@ Set the SYSTEM CONTROL switch on the rear panel of the main
unit to the desired position.
SYSTEM
Note)
Automatic Operation (Except [XR] equipment)
:
When you start playback from a source
component, the input
§
selector on this unit switches to that component automatically.
§
'Except TAPE 2)
Synchronized Recording (Except [XR] equipment)
Lets you synchronize recording with the start of playback when
recording from
CD or MD.
@ This operation does not affect the items stored in memory.
2. Whenplugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging
/ unplugging connection
cords without removal of the power cord can cause malfunctions or damage to the unit.
3. Do not connect up a power source which is larger than that indicated on the socket at the rear of the unit.
4. If thesystem control cords or audio cords are not connected properly, the remote control or automatic operation between system components
will not work properly.
1. Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
Notes'
Advertisement
