Canon imagePASS-P1 Service Manual page 67

7
2x
8
2x
Crossover Ethernet
Cable
62
7. INSTALLATION PROCEDURE
9
CAUTION:
Be sure to use the network cable with Category 5e or
higher. In addition, a shielded type (STP cable) is
recommended. When using the non-shielded type
(UTP cable), it may influence the surrounding
electronic equipments via network cable.
Straight Ethernet Cable
(for network connection)
2x
10
Connect the power plug to the outlet.
CAUTION:
Be sure to use an outlet of a system different from that
of the host machine.
11
After turning ON the power of this equipment, turn ON the
main power switch of host machine.
12
When the message "Turn ON the main power of the host
machine again." is displayed on the Touch Panel, turn OFF
the main power switch.
13
Turn ON the main power switch again.
14
Check that the value of the following service mode(Level 1)
is "458".
• COPIER > OPTION > INT-FACE > CNT-TYPE