Using The Imagepass; Starting, Shutting Down, Rebooting, And Restarting The Imagepass - Canon imagePASS-P1 Service Manual

Using the imagePASS

This chapter describes how to use the imagePASS.

Starting, shutting down, rebooting, and restarting the imagePASS

Always use the following procedures to start, shut down, reboot, or restart the imagePASS.
IMPORTANT:
Always verify that the imagePASS is not in use before you power off or restart it. Make sure that the system is not processing
or printing a job. Before you take the imagePASS off the network, always obtain permission from the network administrator.
To start the imagePASS
1. Press the power switch to set ON (|).
2. Power on the printer using the main power switch.
The imagePASS will automatically turns on as the printer warms up.
If it has been enabled in Setup, the imagePASS Start page will also print automatically when the imagePASS is ready for
use.
NOTE:
If the imagePASS does not start up within 10 minutes, see the Startup section
To shut down the imagePASS
1. Make sure that the imagePASS is not receiving, processing, or printing any jobs.
2. Make sure that the printer is not in use.
3. Power off the printer using the main power switch on the front.
The imagePASS will automatically start the shutdown process. Wait for the printer and the imagePASS to power off
completely.
4. Move the imagePASS power switch to the OFF (O) position.
To restart the imagePASS
1. Make sure that the imagePASS is not receiving, processing, or printing jobs.
2. From the printer control panel, press Main Menu button. If the Fiery icon does not appear on the copier touch panel, press
Show All.
3. From the printer touch panel, select Fiery > Tools > Restart Server.
Figure 2: Starting the imagePASS
7
2. Using the imagePASS
of"Symptoms and solutions" on page 44 .