Applying The Grease - Yamaha FLIP-X Series Maintenance Manual

Hide thumbs Also See for FLIP-X Series:
Table of Contents

Advertisement

3.

Applying the grease

To apply the grease in accordance with the periodic inspection, follow the steps below.
Before applying the grease, thoroughly read the cautions stated in the Safety Guide and "Before beginning
work" in this Chapter to strictly observe the instructions.
When applying grease to the ball screws and linear guide, take the following precautions.
w
WARNING
PRECAUTIONS WHEN HANDLING GREASE:
• INFLAMMATION MAY OCCUR IF THIS GETS IN THE EYES.
BEFORE HANDLING THE GREASE, WEAR YOUR SAFETY GOGGLES TO ENSURE THE GREASE WILL NOT COME IN
CONTACT WITH THE EYES.
• INFLAMMATION MAY OCCUR IF THE GREASE COMES INTO CONTACT WITH SKIN. BE SURE TO WEAR PROTECTIvE
GLOvES TO PREvENT CONTACT WITH SKIN.
• DO NOT TAKE ORALLY OR EAT. (EATING WILL CAUSE DIARRHEA AND vOMITING.)
• HANDS AND FINGERS MIGHT BE CUT WHEN OPENING THE CONTAINER, SO USE PROTECTIvE GLOvES.
• KEEP OUT OF THE REACH OF CHILDREN.
• DO NOT HEAT THE GREASE OR PLACE NEAR AN OPEN FLAME SINCE THIS COULD LEAD TO SPARKS AND FIRES.
EMERGENCY TREATMENT:
• IF THIS GREASE GETS IN THE EYES, WASH LIBERALLY WITH PURE WATER FOR ABOUT 15 MINUTES AND CONSULT A
PHYSICIAN FOR TREATMENT.
• IF THIS GREASE COMES IN CONTACT WITH THE SKIN, WASH AWAY COMPLETELY WITH SOAP AND WATER.
• IF TAKEN INTERNALLY, DO NOT INDUCE vOMITING BUT PROMPTLY CONSULT A PHYSICIAN FOR TREATMENT.
w
WARNING
DISPOSING OF GREASE AND THE CONTAINER:
• PROPER DISPOSAL IS COMPULSORY UNDER FEDERAL, STATE AND LOCAL REGULATIONS. TAKE APPROPRIATE
MEASURES IN COMPLIANCE WITH LEGAL REGULATIONS.
• DO NOT PRESSURIZE THE EMPTY CONTAINER. PRESSURIZING MAY CAUSE THE CONTAINER TO RUPTURE.
• DO NOT ATTEMPT TO WELD, HEAT UP, DRILL HOLES OR CUT THIS CONTAINER. THIS MIGHT CAUSE THE CONTAINER TO
ExPLODE AND THE REMAINING MATERIALS INSIDE IT TO IGNITE.
w
WARNING
WHEN THE BRAKE OF THE vERTICAL AxIS IS RELEASED, THE SLIDER AxIS MAY DROP, LEADING TO HAzARDOUS
SITUATION. WHEN APPLYING THE GREASE TO THE vERTICAL AxIS PARTS, DO NOT RELEASE THE BRAKE.
c
CAUTION
Be sure to wear safety gloves before starting the work. If you touch any steel material part with bare hands, this
may cause rust.
2
2-7

Advertisement

Table of Contents
loading

Table of Contents