Yamaha MTM690 Owner's Manual page 35

ZAUM1360
1. Helmet holding cable
2. Screwdriver
3. Holder
3. Pass the helmet holding cable
through the buckle on the helmet
strap.
4. Hook the cable loops over the
screwdriver, and then install the
screwdriver first into the right-side
holder and then into the left-side
holder.
TIP
Make sure that the screwdriver is se-
curely positioned between its holders,
and then position the cable loops to
the right of the machine before install-
ing the seat.
Instrument and control functions
1
2
3
ZAUM1361
1. Helmet strap buckle
2. Helmet holding cable
3. Screwdriver
5. Install the passenger
WARNING! Never ride with a
helmet attached to the helmet
holder, since the helmet may hit
objects, causing loss of control
and possibly an accident.
To release a helmet from the helmet
holding cable
1. Remove the seat.
2. Remove the screwdriver, then re-
move the helmet holding cable
from the helmet.
3. Store the cable under the seat by
hooking the cable loops over the
screwdriver, install the screw-
3-20
driver in its original position, and
then place the helmet holding ca-
ble under the seat holder.
ZAUM1362
1. Seat holder
seat.
2. Helmet holding cable
3. Screwdriver
4. Install the seat.
[EWA10162]
3