Clutch Lever; Shift Pedal - Yamaha MTM690 Owner's Manual

Instrument and control functions
Start/Engine stop switch " /
To crank the engine with the starter,
set this switch to "
the switch toward "
for starting instructions prior to starting
3
the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU68270
/ "

Clutch lever

", and then slide
". See page 5-1
" to stop the en-
1. Clutch lever
EAU12735
The clutch lever is located on the left
" posi-
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
ECA10062
tion circuit cut-off system. (See page
3-23.)
EAU12822

Shift pedal

1
1. Shift pedal
The shift pedal is located on the left
side of the motorcycle. To shift the
transmission to a higher gear, move
the shift lever up. To shift to the trans-
mission to a lower gear, move the shift
pedal down. (See page 5-2.)
3-13
1
ZAUM1342
EAU12874