Yamaha MTM690 Owner's Manual page 26

Instrument and control functions
This display shows the air temperature
from –9 °C to 99 °C in 1 °C increments.
The temperature displayed may vary
from the actual ambient temperature.
TIP
3
 When the air temperature is below
–9 °C, "Lo" will be displayed.
 The accuracy of the temperature
reading may be affected when rid-
ing slowly (under 20 km/h [12.5
mi/h]) or when stopped at traffic
signals, railroad crossings, etc.
Clock
ZAUM1339
1. Clock
The clock displays time in 12-hour for-
mat. Even when the key is not in the
"ON" position, the clock can be viewed
for 10 seconds by pushing the bottom
set button.
To set the clock
1. Turn the key to "ON".
2. Push the bottom set button and
top set button together for two
seconds and the hour digits will
start flashing.
3. Push the top set button to set the
hours.
4. Push the bottom set button and
the minute digits will start flashing.
5. Push the top set button to set the
minutes.
6. Push the bottom set button to
confirm settings and start the
clock.
TIP
1
 When setting the hours and min-
utes, push the top set button brief-
ly to increase the increment value
one by one, or push and hold the
button to increase the increment
value continuously.
Brightness control
ZAUM1341
1. Brightness level display
The brightness level of the multi-func-
tion meter unit panel can be adjusted
to suit the rider's preference.
To adjust the brightness
1. Turn the key to "OFF".
2. Push and hold the bottom set but-
3. Turn the key to "ON" and continue
4. Push the top set button to set the
3-11
ton.
pushing the bottom set button un-
til the display switches to the
brightness control mode.
brightness level.
1