Table of Contents
Advertisement
Programming the integrated
universal remote control
Functional requirement
The battery of the hand-held transmitter must
be fully charged at the time of programming
to ensure an optimal range of the integrated
universal remote control.
Programming individual buttons
1.
Park the vehicle within range of the remote-
controlled system.
2.
Turn on standby state.
3.
Select desired button on the interior mirror:
▷
Program available button:
Press the button.
▷
Program already assigned button:
Press and hold the button for approx.
20 seconds.
The LED on the interior mirror will slowly
begin flashing orange.
4.
Hold the hand-held transmitter for the
remote-controlled system approx. 1 to
12 in/2.5 to 30 cm away from the buttons
on the interior mirror.
The required distance depends on the
hand-held transmitter.
5.
Press and hold the button on the hand-held
transmitter.
Canada: if programming with the hand-held
transmitter was interrupted, hold down the
interior mirror button and repeatedly press
and release the hand-held transmitter but-
ton for 2 seconds.
6.
The LED can illuminate in different ways:
▷
The LED illuminates green: program-
ming completed.
Release button.
▷
The LED flashes green rapidly: the
hand-held transmitter was detected but
programming is not complete.
Online Edition for Part no. 01405A7D166 - II/23
Interior equipment
Press and hold the button on the interior
mirror for approx. 2 seconds. Perform
this procedure three times.
If the integrated universal remote con-
trol remains nonoperational, continue
with the special features for rolling code
radio systems.
▷
LED does not illuminate green after
60 seconds: programming not com-
pleted.
Repeat steps 3 to 5.
Special feature of the rolling code
wireless system
For systems with a rolling code radio system,
the integrated universal remote control and the
system also have to be synchronized.
Refer to information on synchronization in the
operating instructions of the remote-controlled
system.
1.
Program the desired button on the interior
mirror.
2.
Locate and press the synchronizing button
on the remote-controlled system, such as
on the garage door.
You have approx. 30 seconds for the next
step.
Synchronizing is easier with the aid of a
second person.
3.
Press and hold the programmed button on
the interior mirror for approx. 3 seconds.
If necessary, repeat this step up to three
times in order to end synchronization. Once
synchronization is complete, the program-
med function will be carried out.
Operation
After programming, the remote-controlled sys-
tem can be operated with the button on the
interior mirror.
CONTROLS
257
OwnersManuals2.com
Advertisement
Table of Contents
