Package Contents; Serial Number Locations - Cisco 1700 Hardware Installation Manual

Package Contents

1
Package Contents
The following figure shows the package contents for the 1700, 2700, and 4700. Note that the contents are
subject to change and your exact contents might contain additional or fewer items.
Figure 2: Package Contents
1
3
5

Serial Number Locations

The serial number (SN) for the 1700, 2700, and 4700 is printed on the pullout asset card located on the front
panel as shown in the following figure of the 1700.
Cisco Secure Firewall Management Center 1700, 2700, and 4700 Hardware Installation Guide
4
Use only SFPs have been qualified for use on the management center. Although non-Cisco
Note
SFPs and other Cisco SFPs are allowed, we do not recommend using them because they
have not been tested and validated by Cisco. Cisco TAC may refuse support for any
interoperability problems that result from using an untested SFP transceiver.
Chassis
Cisco rail kit (Cisco part number 800-43376-02)
Cisco Secure Management Center 1700, 2700,
and 4700
This document contains URLs that point to the
product overview, hardware installation guide,
regulatory compliance and safety information
guide, warranty, and licensing pages, and a QR
code that points to the management center
Documentation Portal.
RJ-45 to DP9-RS232 console cable (Cisco part
2
number 72-3383-XX)
4 RJ-45 to RJ-45 Cat 5 Ethernet cable, yellow six
feet long (Cisco part number 72-1482-XX)
6 Two 10-Gb SFP+ transceivers with cables
supported for all models or 25-Gb SFP+
transceivers with cables supported for the 4700
Optional for all models; in package if ordered.
Overview