Cancelling An Inreach Sos Call; Digital Switching; Adding And Editing A Digital Switching Page; Controlling Third-Party Equipment Installed On Your Boat - Garmin ECHOMAP ULTRA 2 Owner's Manual

Cancelling an inReach SOS Call

You can cancel an inReach SOS call you sent using the chartplotter.
1 From the InReach® page, select Conversations.
2 Select the SOS conversation you want to cancel.
3 Select Cancel SOS, and confirm that you want to cancel the SOS call.
Your chartplotter can be used to monitor and control circuits when connected to a compatible digital switching
system.
For example, you can control the interior lights and navigation lights on the vessel. You can also monitor live
well circuits.
For more information about purchasing and configuring a digital switching system, contact your Garmin dealer.

Adding and Editing a Digital Switching Page

You can add and customize digital switching pages on the chartplotter.
1 Select Vessel > Switching >
2 Select Add Page or Edit Page.
3 Set up the page as needed:
• To enter a name for the page, select Name.
• To set up the switches, select Edit Switches.
• To add an image of the boat, select Add BoatView Image.
NOTE: You can use the default vessel image or use a custom image of your vessel. You should save the
custom image to the /Garmin folder on the memory card. You can also adjust the view and placement of
the image.

Controlling Third-Party Equipment Installed on Your Boat

Power-Pole Anchor System
®
Do not engage the Power-Pole Anchor System while underway. Doing so could cause result in an accident
causing property damage, serious personal injury, or death.
If a compatible Power-Pole anchor system is connected to the NMEA 2000 network, you can use the
chartplotter to control the Power-Pole anchor. The chartplotter automatically detects the Power-Pole anchor
system's C-Monster ® gateway on the NMEA 2000 network.
Enabling the Power-Pole Anchor or CHARGE
You must enable an overlay on the chartplotter to control the Power-Pole anchor system or a CHARGE power
management system on your vessel.
1 From the page to which you will add the overlay, select
TIP: To quickly select the overlay, select
2 Select where you want to add the overlay.
3 Select Power-Pole® Anchor or Power-Pole® Charge.
After you enable the Power-Pole overlay on the chartplotter, you must set the Power-Pole installation mode to
match the Power-Pole anchor installation on the boat

Digital Switching

Digital Switching
> Setup.
WARNING
Overlay
™
then Anchor or Charge.
(Setting Up the Power-Pole Anchor,
> Edit Overlays.
page 110).
109