Craftsman 113.248510 Owner's Manual page 14

MODEL 113.248510
2. After layout of cabinet parts, take the lower shelf
and turn upside down on floor. Small front flange
should be pointing upward.
3. Locate the two (2) corner brackets, four (4) 1/4-
20 x 1/2 truss head bolts, Iockwashers, and nuts.
Attach the corner brackets to the front flange in
holes as illustrated. Attach both corner brackets.
o o o o
o o o o
LOWER
SHELF
CORNER /_
BRACKETS 7_
\ ,/:o:
CORNER BRACKETS
4. Locate the two (2) side panels, one (1) shelf
stiffener, and six (6) 1/4-20 x 1/2truss head bolts,
Iockwashers and hex nuts. Place the right side
panel on its back side as illustrated. Stand up the
lower shelf on the rear flange and line up the
holes on the corner bracket and shelf stiffener
with the holes in the side panel. Mount the bolts
in the three holes and tighten hex nuts with a
7/16-inch wrench or socket. Repeat procedure
for left side panel.
SHELF
RIGHT SIDE
SHELF STIFFENER PANEL
REAR FLANGE
5. Locate the two(2) skirts, eight(8) truss head bolts,
Iockwashers and hex nuts. Assemble one(l) skirt to
the front of the cabinet using four(4) bolts, lock-
washers and nuts. Hand tighten only. Stand the cab-
inet upright and assemble the rear skirt to the
cabinet using two(2) truss head bolts Iockwashers
and nuts using the top two holes only. From inside
the cabinet insert two bolts out through the two
remaining holes in the rearskirt. Installlockwashers
and nuts hand tightened only.
REAR SKIRT
/...i RIGHT SIDE PANEL
\\
FRONT
SKIRT
LEFT SI DE
PANEL
SHELF
14