Pcs-C11/C11P Camera Unit - Sony PCS-11 Operating Instructions Manual

g MIC1/MIC2 (PLUG IN POWER)
jacks (minijack)
Connect to the optional PCS-A1 or
PCSA-A3 microphone. Power is
supplied to the microphone from the
Communication Terminal.
h ISDN UNIT connector
Connect to the TERMINAL connector
on the optional PCSA-B384S or PCSA-
B768S ISDN Unit.
i VIDEO OUT AUX jack (phono)
Connect to the video input of the TV
monitor or VCR.
j VIDEO OUT MONITOR MAIN
connector (mini DIN 4-pin)
Connect to the S-video input on the TV
monitor or VCR.
k VIDEO OUT MONITOR SUB
connector (mini DIN 4-pin)
Connect to the S-video input on the
second TV monitor when the system
uses the dual monitor mode.
l IR OUT 1/2 jacks (minijack)
Connect the supplied IR repeater.
Connect the IR repeater for the monitor
connected to the VIDEO OUT
MONITOR MAIN connector to the IR
OUT 1 jack, and the IR repeater for the
monitor connected to the VIDEO OUT
MONITOR SUB connector to the IR
OUT 2 jack.
m 100BASE-TX/10BASE-T connector
(8-pin modular)
Used to conduct a conference via a
LAN. Connect to a hub using the
category 5 cable.
n DC 19.5V jack
Connect the supplied PCS-AC195 AC
power adaptor.
o
U (ground) terminal
Connect a ground wire.

PCS-C11/C11P Camera Unit

Front
3
4
5
Rear
Bottom
a Lens
b Microphone
c POWER indicator (green)
Lights when the power switch on the
Communication Terminal is set to on
and goes out when it is set to off or the
Terminal is set to standby mode.
d Remote sensor
Point the Remote Commander to the
sensor when operating this System.
Location and Function of Parts and Controls
1
2
TERMINAL VISCA OUT
6 7
8
175