Switching The Picture Displayed On Dual Monitors - Sony PCS-11 Operating Instructions Manual

Switching the Picture Displayed on Dual Monitors

You can display the following pictures on the first or second monitor while in
communication.
First monitor
First monitor
• Enables display of motion pictures on the local or remote site.
• To switch between the local and remote pictures, press the FAR/NEAR
button on the Remote Commander to display the Display Control menu, then
select "Far" (remote party) or "Near" (local party) under "Display".
Second monitor
• Enables display of motion pictures on the local site, a still image received or
transmitted, a picture from a computer (RGB picture) received or a
whiteboard picture received.
• Each press of the DISPLAY button on the Remote Commander changes the
displayed picture.
Notes
• You cannot change the displayed picture by pressing the DISPLAY button if there are
no still image, no picture from a computer (RGB picture) received, etc.
• As a computer picture (RGB picture) is output by being converted into a 4CIF signal,
the picture cannot be obtained in its original high resolution and the details cannot be
clearly seen. The number of frames displayed per second depends on the transmission
rate, for example, one frame per second at 1 Mbps.
120
Using Two Monitors — Dual Monitor
Local party
Remote party
FAR/NEAR
button
Remote party
Local party
Second monitor
DISPLAY button
Local party
Still image
Picture from a
computer
(RGB picture)
received
Picture on a
whiteboard
received