Conducting A Data Conference Using Netmeeting - T.120 Data Conference - Sony PCS-11 Operating Instructions Manual

Conducting a Data Conference Using
NetMeeting – T.120 Data Conference
Connecting the Communication Terminal to the computer with NetMeeting*
installed enables conduct of a data conference in compliance with the T.120
standard of the ITU-T Recommendation via the PCS-11/11P Video
Communication System only when it is connected over ISDN.
*
NetMeeting is a registered trademark of Microsoft Corporation.
Note
When the PCS-11/11P Video Communication System is connected with a
videoconferencing system at the remote party via LAN, conduct the T.120 data
conference without using the PCS-11/11P.
To connect a computer
To connect a computer to the connector on the Communication
Terminal
Use a commercially available UTP cross cable (category 5) to connect the
LAN connector on the computer with the 100BASE-TX/10BASE-T connector
on the Communication Terminal.
TERMINAL VISCA OUT
AUDIO OUT AUX1– VIDEO IN –AUX2 AUDIO IN CAMERA UNIT MIC
(PLUG IN POWER)
1 2
(MIXED)
VIDEO OUT 100BASE-TX
AUX MAIN– MONITOR– SUB 10BASE-T
IR OUT
1 2
to 100BASE-TX/
10BASE-T
UTP cross cable
(not supplied)
to LAN
connector
Computer
Conducting a Data Conference Using NetMeeting – T.120 Data Conference
PCSA-B384S/
ISDN UNIT B768S ISDN
DC 19.5V
Units
*
ISDN
*
The illustration shows example of when
using the PCSA-B768S ISDN Unit.
TERMINAL VISCA OUT
AUDIO OUT AUX1– VIDEO IN –AUX2 AUDIO IN CAMERA UNIT
(MIXED)
VIDEO OUT 100BASE-TX
AUX MAIN– MONITOR– SUB 10BASE-T
IR OUT
1 2
to 100BASE-TX/
*
10BASE-T
UTP cross cable
(not supplied)
Computer
MIC
ISDN UNIT
(PLUG IN POWER)
1 2
DC 19.5V
to LAN
connector
131