Miele G 7561 Operating Instructions Manual page 101

Problem
The in-operation indica-
tor light is flashing
quickly.
At the end of the pro-
gram, the alarm tone
sounds and the display
shows the following
message:

Fault F601
The in-operation indica-
tor light is flashing
quickly.
At the end of the pro-
gram, the alarm tone
sounds and the display
shows the following
message:
AutoDos maintenance re-
quired
The dishwasher does
not turn off at the end
of the program.
The dishes may not be
clean because an insuf-
ficient amount of deter-
gent was dispensed.
The  AutoDos func-
tion is automatically de-
activated during the
program sequence.
Frequently asked questions
Possible cause and solution
There is a fault in the AutoDos.
 Turn the dishwasher off and back on again.
 Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see "Auto-
matic dispensing/AutoDos" under "Detergent").
 Activate the  AutoDos function and start the pro-
gram again.
If the fault message appears again, there is a techni-
cal fault. You can continue to use your dishwasher by
deactivating automatic dispensing using the  Auto-
Dos sensor button and manually dispensing the de-
tergent via the detergent compartment.
 If you wish to use automatic dispensing again,
contact Miele Customer Service.
An empty PowerDisk has been inserted or the Auto-
Dos is blocked by residual detergent. Detergent
dosage is insufficient.
The  AutoDos function was automatically deacti-
vated.
 Turn the dishwasher off and back on again.
Multiple messages appear in the display.
 Clean the pouring channel of the AutoDos (see
"Cleaning the AutoDos" under "Detergent").
 Clean the lower spray arm (see "Cleaning the
spray arms" under "Cleaning and care").
 Select OK to confirm each message.
 Activate the  AutoDos function by confirming the
message AutoDos available
 Start the program again.
The program duration will be extended by up to
2.5 hours to flush out the AutoDos detergent outlet.
with OK.
101