Table of Contents
Advertisement
Guide to the appliance
Display functions
The display is used to select or set the
following:
- the program
- the Timer
- the
Settings
The display can show the following:
- the program stage
- The estimated time left for the pro-
gram to run
- Any relevant fault messages and in-
formation
To save energy, the dishwasher turns
off after a few minutes if you do not
press any sensor buttons during this
time.
Touch the sensor button to turn the
dishwasher back on.
20
The OK sensor button is used to con-
firm a message or setting and also to
move to the next menu or another level.
Under More, a scroll bar will ap-
pear in the right of the display. This of-
fers further options. These options can
be shown using the sensor but-
tons.
You can alter the dishwasher's controls
to suit changing requirements in the
"Settings" menu (see "Settings").
The option which is selected will have a
check next to it.
To exit a sub-menu again, use the Back
sensor button.
If you do not press any sensor buttons
for several seconds, the display will re-
vert to the previous menu. You will then
have to enter your settings again.
These operating instructions apply to
several different dishwasher models of
different heights.
The specific dishwasher models are
referred to as follows:
Standard = 31 11/16" (80.5 cm) high
dishwashers (integrated)
and 33 1/4" (84.5 cm) high dishwash-
ers (freestanding)
XXL = 33 1/4" (84.5 cm) high dish-
washers (integrated).
Advertisement
Table of Contents
