Step 4: Installing Anti-Tip Device - Thermador PRG486GDH Installation Manual

• Remove the outer carton and packing material from the
shipping pallet. The all gas ranges are held to the pallet
by four (4) bolts (see Figure 5). The two front pallet
bolts are accessible only after removing the Kick Panel.
Remove the two screws below the lower corners of the
oven cavity and lift the Kick Panel away from the two
projections on the range's cast base that capture the
bottom edge of the Panel. After removing the bolts, the
range must be lifted and removed from the pallet.
CAUTION:
DO NOT lift the range by the oven door's
handle, as this may damage the door hinges
and cause the door to fit incorrectly to the oven
cavity.
Chart A
Shipping Weight
Weight without
packing materials
Without door(s),
burner caps, front
kick panel and oven
racks
Pallet
Figure 5: Removal of the Four (4) Shipping Bolts
Note:
Leave adhesive-backed foam layer over brushed-metal
surfaces, to protect finish from scratches, until the range is
installed in its final position.
30" 36"
Range Range Range
300 lbs. 335 lbs. 534 lbs.
265 lbs. 300 lbs. 469 lbs.
142 lbs. 207 lbs. 322 lbs.
• Due to the weight, a dolly with soft wheels should be
used to move this unit. The weight must be supported
uniformly across the bottom (See Figure 6).
• After transporting the range by dolly close to its final
location, the range can be tipped back and supported
on the rear legs while the dolly is carefully removed.
THE FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION. The anti-tip device must be installed
(STEP 4), gas and electrical connections should be
made (STEPS 5 and 6), and the backguard installed
(STEP 7) before the range is placed in its final position.
• Do not install the oven door(s) until the range is in its
final location.
48"
Remove all tape and packaging before using the appliance.
Destroy the packaging after unpacking the appliance.
Never allow children to play with packaging material.
Step 4: Installing Anti-Tip
Device
For all 30" and 36" ranges,
installed per these instructions.
WARNING — RANGE TIPPING
HAZARD
•
•
•
Figure 6: Dolly Positioning
an anti-tip device must be
All ranges can tip and injury can result. To
prevent accidental tipping of the range,
attach it to the floor, wall or cabinet by
installing the Anti-Tip Device supplied.
A risk of tip-over may exist if the appliance
is not installed in accordance with these
instructions.
If the range is pulled away from the wall for
cleaning, service or any other reason,
ensure that the Anti-Tip Device is properly
Range
Must be
Uniformly
Supported
by Braces
Provided
on Bottom
of Range
English 9