Previewing The Image; Checking A Preview Image; Preparing The Fabric; Attaching Stabilizer (Backing) To Fabric - Baby Lock Capella Instruction And Reference Manual

PREVIEWING THE IMAGE

Checking a preview image

Display the preview image to check that the embroidery will
be performed as desired.
a Touch .
 The preview image is displayed.
b Touch or to display the desired type of frame,
and then select the embroidery frame. Touch
fill the screen with just the pattern.
• After determining the type of Embroidery Frame
Holder and size of embroidery frame that are best for
your embroidery, change the Embroidery Frame
Holder and embroidery frame that are installed. The
machine will automatically detect the Embroidery
Frame Holder and embroidery frame and change the
display.
• Touch again to also display the embroidery
frame.
c Touch to return to the previous screen.
Memo
• Embroidering can be started while the preview
image is displayed in the embroidery screen. If the
preview image is displayed in any screen other
than the embroidery screen, embroidering cannot
be started.

PREPARING THE FABRIC

CAUTION
• Your machine can embroider fabric that is up
to 2 mm (approx. 5/64 inch) thick. If thicker
fabric is embroidered, the needle may break
and cause injury.

Attaching stabilizer (backing) to fabric

In order to prevent shrinkage of the stitching or misaligned
to
patterns, we recommend that stabilizer (backing) be used for
embroidering.
CAUTION
• When embroidering on thin or stretch fabrics,
fabrics with a coarse weave or fabrics that
easily allow the stitching to shrink, be sure to
use stabilizer (backing) for embroidering. Not
using a stabilizer (backing) may cause the
needle to break and cause injury.
a Using a steam iron, affix the iron-on stabilizer
(backing) to the back of the fabric.
• Use a piece of stabilizer which is larger than the
embroidery frame being used.
1 Adhesive side of iron-on stabilizer (backing)
2 Fabric (wrong side)
3 Size of the embroidery frame
Memo
• When embroidering light or open designs on thin
fabrics, such as organza or lawn, use a water-
soluble stabilizer (backing). Water-soluble
stabilizers dissolve when washed, allowing you to
create beautiful embroidery that is not stiff.
• When embroidering fabric that should not be
ironed or when embroidering an area that is difficult
to iron, hoop a layer of the stabilizer (backing)
under the fabric in the embroidery frame without
ironing it.
BASIC EMBROIDERY
a
b
c
49
2