Table of Contents
Advertisement
If the bobbin thread ran out, replace the
bobbin at this point in the procedure.
c
Replace the bobbin with a bobbin wound with bobbin
thread. (page 25)
• If the hook cover can be opened, replace the bobbin
without removing the embroidery frame from the
machine.
• If the machine bed is hidden, for example, with a bag-
shaped piece of fabric, or if the hook cover cannot be
opened, temporarily remove the embroidery frame.
(page 70) After replacing the bobbin, re-attach the
embroidery frame. (page 54)
Note
If the embroidery frame is removed before
embroidering of the pattern is finished, take caution,
otherwise the pattern may become misaligned.
• Do not apply extreme pressure to the framed fabric
and cause it to become loose.
• When removing and re-attaching the embroidery
frame, do not allow the frame to hit the carriage or
the presser feet.
If the carriage is hit and moves, turn the machine
off, then on again. The correct frame position at the
time that the machine was stopped is stored in the
machine's memory, and the embroidery frame is
returned to the correct position.
• When the embroidery frame is re-attached, make
sure that the pins on the left and right arms of the
Embroidery Frame Holder securely fit into the holes
in the handles on the embroidery frame.
d
Go back through the stitching in the same way as that
b
described in step
through
thread breaks" on page 71, and then continue
embroidering.
72
e
of "If the upper
Embroidering from the beginning or middle
of the pattern
If you wish to restart embroidering from the beginning, for
example, if trial embroidery was performed and an incorrect
thread tension was used or if the wrong thread color was
used, restart the embroidering using the forward/backward
stitch key. In addition, you can go forward or back through
the stitching by thread color or by stitch to start stitching at
any position of the pattern.
Note
• Be careful when going back or forward through the
stitching since the embroidery frame moves at the
same time.
a
Press the "Start/Stop" button to stop the machine.
• If necessary, trim and remove the embroidered
stitches.
b
Touch
.
The stitch navigating screen appears.
c
Touch
and
to select a color in the thread color
sequence, and then touch
,
,
and
• Touch
to embroider from the beginning.
1 Touch this key once to return to the beginning of the
stitching for the color being embroidered. Afterward,
each touch of this key returns to the beginning of the
previous thread color.
2 Each touch of this key advances to the beginning of
embroidering the next thread color.
The needle bar moves to the embroidering position,
and then the embroidery frame moves and current
needle position is indicated.
d
After selecting the stitch from where embroidering is
to begin, touch
.
The embroidery screen appears again.
Touch
, and then press the "Start/Stop"
e
button to start embroidering.
Embroidering starts from the specified point.
,
,
,
,
to select the stitch.
1
2
Advertisement
Table of Contents
