Baby Lock Capella Instruction And Reference Manual page 30

h Wind the thread clockwise around the bobbin 4 or 5
times, as shown in the illustration.
i Pass the end of the thread through the guide slit on the
bobbin winder seat, and pull the thread. The cutter will
cut the thread.
1 Guide slit (with built-in cutter)
2 Bobbin winder seat
CAUTION
• Be sure to follow the procedure described. If
the bobbin is wound without the thread being
cut with the cutter, when the bobbin thread
runs low, the thread may become tangled
around the bobbin and cause the needle to
break, resulting in injury.
j Push the bobbin winding switch to the left, until it
clicks into place.
 The bobbin winding window will be displayed on
the LCD screen.
1 Bobbin winding switch
28
k Touch .
1
1 Touch to decrease the bobbin winding speed.
2 Touch to increase the bobbin winding speed.
 The bobbin starts winding. The bobbin stops rotating
when bobbin winding is completed. The bobbin
winding switch will automatically return to its
original position.
Memo
• changes to
winding. Touch
the bobbin is fully wound.
• Stay near the machine while winding the bobbin to
make sure the bobbin thread is being wound
correctly. If the bobbin thread is wound incorrectly,
touch immediately to stop the bobbin
winding.
• Touch to minimize the bobbin winding
window. Then, you can perform other operations,
such as selecting a pattern or adjusting the thread
tension, while the bobbin is being wound.
• Touch (in top right of the LCD screen) to
display the bobbin winding window again.
l Cut the thread with the cutter and remove the bobbin.
1 Cutter
IMPORTANT
• When removing the bobbin, do not pull on the
bobbin winder seat. Doing so could loosen or
remove the bobbin winder seat, and could
result in damage to the machine.
2
while the bobbin is
if you want to stop before