Smeg SOPA6302S2PN Manual page 39

2. Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
3. Press the button to start the function.
The descaling solution starts to flow into the
deep pan from the drain pipe on the right side
of the rear wall of the oven cavity.
4. Wait for the end of the drain flow.
A beep sounds when finished.
5. Drain the descaling solution from the deep
pan.
Take care: the descaling solution may
be still hot.
Rinse
Once the descaling agent has been drained,
the hydraulic circuit must be rinsed with clean
water.
Use cold tap water which is not too
hard, softened water or still mineral
water.
Do not use distilled water, tap water
with a high chloride content (> 40 mg/
l), or other liquids.
The display will show the request to fill the
reservoir with water.
1. Open the door.
2. Place the deep pan on the third shelf from
the bottom. Push the tray up against the rear
wall of the oven cavity.
3. Pull the loading drawer out of its housing.
4. Insert the funnel provided in the loading
drawer.
5. Using a bottle or measuring jug, pour in
enough water to allow some to overflow
91477A113/B
into the oven cavity (about 1.2 litres is
recommended).
The overflowing of water inside the
oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
6. Press the button to start the function and
wait one minute.
At the end, the appliance makes a beep and
the display shows the request to drain the
reservoir (the indicator light
7. Press the button again to start the
function.
8. Wait for the end of the drain flow.
A beep sounds when finished.
9. Drain the water from the deep pan.
The display shows the new request to fill the
reservoir with water.
10 Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
11. Pour one litre of water into the funnel placed
in the loading drawer (using a bottle or a
graduated jug) until it has overflown to the
bottom of the cavity.
12. Press the button to start the function and
wait one minute.
At the end, the appliance makes a beep and
the display shows the request to drain the
reservoir (the indicator light
13. Press again the
from the reservoir into the deep pan.
14. Wait for the end of the drain flow.
A beep sounds when finished. The appliance
automatically switches to the sanitization
procedure.
Sanitization
Sanitization with steam allows to
remove the last residues of descaling
from the hydraulic circuit.
The display will show the request to fill the
reservoir with water.
1. Open the door.
CLEANING AND MAINTENANCE - 41
comes on).
comes on).
button to drain the water