Craftsman 919.762500 Owner's Manual page 7

5. _ Cut tie wrap off of high pressure hose, Unwind
high pressure hose to attach the threaded end to
_e gURo
6. • Connect chemical hose to the chemical injector
hose barb on pump.
8. _ Your units pump is shipped with a tempo_'a_
p_ug that must be repiaced with a breather cap,
This p_ug is located over the pump's oil port.
Unscrew and remove this plug. Remove the
breather cap from the bag attached to the plug
and instalJ it in the pump's oil port,
BREATHER
CAP
CHEMICAL
INJECTOR
HOSE
PUMP
,& CAUTION" Failure to replace the plug will result
in serious pump damage.
9. • Place assembled gun and wand on pressure
washer's handle bracket as shown.
I
7. , Connect high pressure hose to the quick connect
outlet on pressure washer.
Uti ' 1;
CONNECT
NOTE: Always keep hose away from engine
muffier,
Checklist
Before going any further please review the following:
Be sure you have completed assembly instruction.
Double check aH fittings to be s{._rethey are tight.
IMPORTANT: Before any attempt to sta_ your pres-
sure washer be sure to check engine oit (See Operation
under Engine Oil, page 9.}