Philips 51PP9200D/37 Service Manual page 135

Chassis ebj1.0u ra
Hide thumbs Also See for 51PP9200D/37:
Table of Contents

Advertisement

8.4
Option Settings
8.4.1
Introduction
The microprocessor communicates with a large number of I
ICs in the set. To ensure good communication and to make
digital diagnosis possible, the microprocessor has to know
which ICs to address. The presence / absence of these specific
ICs (or functions) is made known via the option codes.
Notes:
After changing the option(s), save them via "STORE".
The new option setting is only active after the TV is
switched "off" and "on" again with the Mains switch (the
EAROM is then read again).
8.4.3
Dealer Options
Table 8-4 Dealer options
Menu item
Subjects
Personal Options
Picture Mute
Virgin Mode
2CS Korea
8.4.4
(Service) Options
Select the sub menu's to set the initialization codes (options).
Table 8-5 Service options
Menu-item
Subjects
PIP/DS
Dual Screen
Data
EPG
RRT
Display
Screen
Scanning Backlight
Dimming Backlight
Video Repro
Picture Processing
Comb filter
Ambient Light
MOP
Source Selection
HDMI 1
HDMI 2
USB version
IEEE1394
Ethernet
S/PDIF inputs
Audio Repro
Subw. Internal Present
Acoustic System
Miscellaneous
Alternative Tuner
Tuner Type
Hotel mode
Option numbers
Group 1
Group 2
Store
2
C
Options
Description
On
Picture mute active in case no picture detected
Off
Noise in case of no picture detected
On
TV starts up (once) with a language selection menu after the Mains switch is turned "on" for the first time (virgin mode)
Off
TV does not start up (once) with a language selection menu after the Mains switch is turned "on" for the first time (virgin mode)
On
only for AP region
Off
Options
Description
None / 1 tuner / 2 tuners
no DS / DS with one tuner / DS with two tuners
Off / On
Feature not present / present
No / Yes
Parental control is enabled via the Regional Rating
Table (RRT)
034 / 035 / 036
Used screen size, type, and resolution (see table
"Display code overview" in chapter "Service
Modes"for the values)
On / Off
Feature present / not present
On / Off
Feature present / not present
Spider / No Spider
Feature present / not present
None / 2D / 3D
Only selectable with Columbus in set: No / without
RAM / with RAM
None / Mono / Stereo
Inverter not present / two inverters mono / two
inverters stereo
On / Off
Feature present / not present (for sets with AmbiLight
this is "on")
None / Audio / No Audio
No HDMI / HDMI with analog audio / HDMI without
analog audio
None / Audio / No Audio
No HDMI / HDMI with analog audio / HDMI without
analog audio
None / 1.1 / 2.0 + CR
No USB / USB 1.1 in side I/O panel / USB 2.0 in
cardreader panel
Yes / No
Firewire connector present / not present
Yes / No
Connector present / not present
None / 1 conn. / 2 conn.
None / 1 connector present (in)/ 2 connectors present
(in/out)
Yes / No
Internal sub woofer present / not present
51 / 60 Philips
51" / 60"
Philips
Tuner brand
TD1336s
Tuner type
Off / On
iBoard present
"Value"
00016 0001x 00545 14979 (see set sticker)
"Value"
00034 00000 16928 00000 (see set sticker)
OK
To store changed option numbers
Alignments
EBJ1.0U
8.4.2
Option Codes
Enter the Service Alignment Mode (SAM) by pressing the
following key sequence on the remote control transmitter:
0-6-2-5-9-6-[i+]. Do not allow the display to time out while
entering the key sequence.
Cursor to the OPT. NO. in the SERVICE OPTIONS level.
Locate the "option code label" on the inside right panel of the
unit and enter the correct codes for the model being serviced.
Note: Remember to cursor to the STORE OPTIONS level and
select "OK" to save these changes
Table 8-3 Option numbers
Model number Group 1
51MP6200D/37 00016 00015 00545 14979
51PP9200D/37 00016 00016 00545 14979
60PP9200D/37 00016 00017 00545 14979
Remarks
Not applicable in these sets
Electronic Program Guide: off for legal reasons
Magnavox 51" or Philips 51" / 60"
Not applicable in these sets
Not applicable in these sets
Not applicable in these sets
Not applicable in these sets
Not applicable in these sets
Not applicable in these sets
Not applicable in these sets
Not applicable in these sets
Cabinet design, used for setting dynamic audio
parameters.
Not applicable in these sets
x=5: Magnavox 51", x=6: Philips 51", x=7: Philips 60"
8.
EN 135
Group 2
00034 00000 16928 00000
00034 00000 16928 00000
00034 00000 16928 00000

Advertisement

Table of Contents
loading

This manual is also suitable for:

51mp6200d/3760pp9200d/37

Table of Contents