Philips 51PP9200D/37 Service Manual page 11

5
Figure 4-12 Small signal module 4/4
4.1.9 Front Control Panel Removal
1. Remove the Lower Front Cover.
2. Remove screws [1] (see Figures "Front Control Panel").
3. Release clamps [2] and remove the Front Control Panel.
4. Loosen the connectors.
1
Figure 4-13 Front control panel
Mechanical Instructions
G_15860_069.eps
100406
1
2
G_15860_071.eps
100406
EBJ1.0U
4.1.10 Side I/O Panel Removal
1. Remove the Left Side Back Cover (see procedure above).
2. Disconnect the connectors [1] from the panel.
3. Remove two screws [2] from the panel.
4. Slide the Side I/O Panel CBA out of the bracket.
Figure 4-14 Side I/O panel
4.1.11 Small Signal Board Removal (SSB)
First, remove the Module Bracket (see the chapter "Small
Signal Module Removal").
1. Remove screws [1].
2. Remove the top shield.
3. Lift the SSB with the bottom shield out of its plastic retainer.
1. Remove screws [2] and [3].
1. Lift the SSB out of the bottom shield.
1
1
1
Figure 4-15 Small signal board 1/3
Figure 4-16 Small signal board 2/3
4. EN 11
2
1
2
G_15860_070.eps
1
1
1
1
1
G_15860_072.eps
2
G_15860_073.eps
100406
100406
100406