Table of Contents
Advertisement
USBPROCESS
Connectingexternaldatamedia
It is advised to put the television on stand-by
mode before connecting the External Data
medium. Connect the device and then switch the
television on again.
Before disconnecting the data medium, the
television must first be switched to standby,
otherwise files can be damaged.
Notes:
USB1 port of the TV supports 500 mA
7
current according to the USB standard.
Devices such as external hard disk and
etc. that consume more power can only be
connected to the USB2(HDD) interface of
the television.
If you are using a power cable for the
7
external hard disk that you have connected
to the USB2(HDD) USB interface, then
the power cable of the external hard disk
must also be unplugged when the TV is
turned off.
You must not disconnect the USB Device
7
from the TV while a file on the USB Device
is being read by the TV.
A bi-directional data transfer as defined for
7
ITE (Information Technology Equipment)
devices in EN 55022/EN 55024 is not
possible.
USB transfer is not an operating mode in
7
itself. It is only an additional function.
I f the product cannot be recovered in the
7
data playing/sharing/recording mode due
to electrostatic discharge, user intervention
will be required.
-----------------------------------------------------------------------------------------------------
USB2
(HDD)
1
Connect the USB2(HDD) interface of the
television and the corresponding socket on
the data device (external hard drive, digital
camera, card reader or MP3 player) using
a USB cable;
or
plug the memory stick in one of the »USB1«
socket of the television.
ENGLISH
43
Advertisement
Table of Contents
