Changing The Program After It Is Started; Cancelling The Program; End Of Program - Beko BT3103IS User Manual

2. To deactivate the child lock, keep the
same button pressed for 3 seconds
again.
When the drying machine is oper-
ated and the child lock is active, if
the program selection button is
turned, a double beeping noise will
be heard. If the child lock is deactiv-
ated before the program selection
button is turned to its original place,
the program will be terminated be-
cause the program selection button
will be displaced.
9.9 Changing the Program After It Is
Started
You can change the program you selected
to dry your laundry with a different program
after the drying machine starts running.
1. For example, turn the On/Off/Program
Selection button to select the Extra Dry
program in order to select the Extra Dry
program instead of Ironing Dryness
after pressing the Start / Standby selec-
tion button.
2. Press the Start/Standby button to start
the program.
Adding and removing clothes during
standby state
If you want to add or remove clothes to/
from the drying machine after the drying
program has started:
1. Press the Start/Standby button to put
the drying machine in Standby state.
The drying operation stops.
2. Open the loading door while in Standby
state, and close the door after you re-
move or add laundry.
3. Press the Start/Standby button to start
the program.
Adding laundry after the drying op-
eration starts may cause the dried
laundry inside the drying machine
to mix with wet laundry and leave
the laundry damp at the end of op-
eration.
Adding or removing laundry during
drying may be repeated as many
times as you wish. But this opera-
tion continuously interrupts the dry-
ing operation and thus increases
program time and energy consump-
tion. So, it is recommended to add
laundry before the program starts.
If a new program is selected by
turning the program selection but-
ton while the drying machine is in
standby state the running program
terminates.
Do not touch the inner surface of
the drum while adding or removing
clothes during a continuing pro-
gram. The drum surface is hot.

9.10 Cancelling the Program

If you want to cancel the program and ter-
minate the drying operation for any reason
after the drying machine starts running,
turn the On/Off/Program Selection button
after pressing the Start / Standby selection
button; and the program terminates.
The inside of the drying machine
shall be extremely hot when you
cancel the program during machine
operation, so run the refreshing pro-
gram to allow it to cool down.

9.11 End of Program

When the program ends, the LEDs of End/
Wrinkle Prevention and Fiber Filter Cleaning
Warning on the program follow-up indicator
turn on. Loading door can be opened and
drying machine is ready for another opera-
tion.
Turn the On/Off/Program Selection button
to On/Off position in order to turn the dry-
ing machine off.
EN / 59
IT
EN