Table of Contents
Advertisement
FCC Statements (for the United States only)
Federal Communications Commission (FCC) Notice (U.S. Only) WARNING: This equipment has been
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received including interference that may cause undesired
operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
For UK only
The mains lead (power cable) on the equipment comes with a moulded plug incorporating a fuse.
The rating of the fuse is indicated on the pin face of the plug and, if it requires replacing, a fuse approved by
ASTA or BSI to BS 1362 of the same rating must be used.
If the plug has a detachable fuse cover, remember to place the fuse cover back if you need to change the
fuse.
Do NOT use a plug without the fuse cover. If the fuse cover is missing, contact your nearest BenQ Customer
Service Center for assistance.
UKCA Declaration of Conformity
The object of the declaration described above is in conformity with the relevant UK harmonisation
legislation:
• Electromagnetic Compatibility Regulations 2016
• Electrical Equipment (Safety) Regulations 2016
• The Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations
2019
• The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012
For Europe only
CE DOC
DECLARATION OF CONFORMITY
The device complies with the requirements set out in the Council Directives relevant Union harmonisation
legislation:
• LVD Directive 2014/35/EU
• EMC Directive 2014/30/EU
• RoHS Directive 2011/65/EU & (EU) 2015/863
• Ecodesign Directive 2009/125/EC
• WEEE Directive 2012/19/EU
• Turkish ErP (Decision 2010/643)
DÉCLARATION DE CONFORMITÉ
L'appareil est conforme aux exigences définies dans les directives du Conseil relatives à la législation
d'harmonisation de l'Union :
• Directive LVD 2014/35/UE
• Directive EMC 2014/30/UE
• Directive RoHS 2011/65/UE et (UE) 2015/863
• Directive sur l'écoconception 2009/125/CE
• Directive DEEE 2012/19/UE
• ErP turque (décision 2010/643)
20
English
Français
Advertisement
Table of Contents
