Table of Contents
Advertisement
Installing remote control batteries
Using BenQ Interactive Flat Panel by remote control
1. Insert the remote control USB receiver into the USB-A ports at the lower left corner on the
rear side of the display.
2. Aim the remote control at the sensor at the display's bottom-right side within a distance of
less than 8m, and a horizontal and vertical angle of less than 60 degrees.
• The remote control and the USB receiver have been paired by default.
• This remote control applies only to a specific model and operating systems. Contact your reseller if you
have any question.
1. Open the remote control battery cover.
2. Insert the supplied batteries, ensuring the positive
and negative ends are facing in the correct direction.
The supplied batteries are provided for your convenience so
that you can operate the display straight away. You should
replace them as soon as possible.
3. Put the cover back on.
Max. 8 m
12
Advertisement
Table of Contents
