Brother MFC8440D Service Manual page 208

7/13/2019
Error Message
DX Lever Error
Fuser Open
Machine Error XX
Out of Memory
No
Response/Busy
Not
Registered
PLS Open Cover
http://slidepdf.com/reader/full/brother-8840d-service-manual
Brother 8840D Service Manual
Cause
The paper adjustment lever for
duplex printing is not correctly set
for the paper size.
The fuser cover is open.
Machine has a mechanical
problem.
You can't store data in the
memory.
The number you dialed does not
answer or is busy.
You tried to access a One-Touch
or Speed-Dial number that is not
programmed.
A page, piece of paper or paper
clip, etc. may be jammed inside
the machine.
6-5
MFC-8440/8840D/8840DN, DCP-8040/8045D/8045DN
Action
Set the duplex lever to the correct
position.
Please close the jam clear cover.
(See Paper Jam on page 6-13.)
Refer to '2.2 Error Codes Shown in
the "MACHINE ERROR X X"
message'.
(Fax sending in process)
Press Stop button and wait until the
other operations in progress finish
and then try again.
- OR -
Clear the data in the memory.
(Copy operation in process)
Press Stop button and wait until the
other operations in process finish
and then try again.
- OR -
Clear the data in the memory.
- OR -
Add an optional memory.
(Printing operation in process)
Reduce print resolution.
- OR -
Clear the data in the memory.
- OR -
Add an optional memory.
Verify the number and try again.
Set up the One-Touch or Speed-
Dial number.
Open the front cover. If you see
any jammed paper or other item,
gently pull it out, then close the
front cover. If the error message
remains, open and close the front
cover again. If the machine cannot
reset itself and return to the date
and time prompt, it will display
Machine Error XX.
Refer to '2.2 Error Codes Shown in
the "MACHINE ERROR X X"
message'.
SERVICE MANUAL
208/361