Table of Contents
Advertisement
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
Steps
1. Remove the
optical
drive.
2. Remove the
base
cover.
3. Remove the
wireless
card.
Procedure
Steps
1. Lift the latch and disconnect the optical-drive connector-board cable from the optical-drive board connector.
2. Peel the tape that secures the display-cable connector latch to the system board.
3. Open the latch and disconnect the display cable from the system board.
4. Note the routing of the display cable and remove the cable from its routing guides on the fan and palm-rest and keyboard
assembly.
5. Remove the six screws (M2.5x5) that secure the left and right hinges to the system board and palm-rest and keyboard
assembly.
6. Open the hinges.
Removing the display assembly
computer. After working inside your computer, follow the instructions in
After working
www.dell.com/
Removing the display assembly
40
91
Advertisement
Table of Contents
