Table of Contents
Advertisement
Setting
IKE Version
Authentication Method
Pre-Shared Key
ID Type
ID
Encapsulation
Remote Gateway(Tunnel Mode)
Security Protocol
Algorithm Settings
Group Policy Guidelines
Options/Description
Select IKEv1 or IKEv2 depending on the device that the
product is connected to
If you selected IPsec as the Access Control option,
select an authentication method here
If you selected Pre-Shared Key as the Authentication
Method option, enter a pre-shared key between 1 and
127 characters long here and in the Confirm Pre-Shared
Key field
If you selected IKEv2 as the IKE Version setting, select
the ID type from the list
If you selected IKEv2 as the IKE Version setting, enter
the necessary ID information
If you selected IPsec as the Access Control option,
select one of these encapsulation modes:
Transport Mode: if you are using the product on the
same LAN; IP packets of layer 4 or later are encrypted
Tunnel Mode: if you are using the product on an Internet-
capable network, such as IPsec-VPN; the header and
data of IP packets are encrypted
If you selected Tunnel Mode as the Encapsulation
option, enter a gateway address between 1 and 39
characters long
If you selected IPsec as the Access Control option,
select one of these security protocols:
ESP: to ensure the integrity of authentication and data,
and encrypt data
AH: to ensure the integrity of authentication and data; if
data encryption is prohibited, you can use IPsec
Select the encryption algorithm settings for the security
protocol you selected
342
Advertisement
Table of Contents
