Communication With The Dog Collar Device - Garmin Alpha 300i Owner's Manual

With training

Hide thumbs Also See for Alpha 300i:

Table of Contents

3 Tighten the strap so that it is snug around the dog's neck, and fasten the buckle.

NOTE: The collar should fit tightly and should not be able to rotate or slide on the dog's neck. The dog must

be able to swallow food and water normally. You should observe your dog's behavior to verify that the collar

is not too tight.

4 Wiggle the device to work the contact points through the dog's coat.

NOTE: The contact points must have contact with the dog's skin to be effective.

5 If the strap is too long, cut off the excess, leaving at least 7.62 cm (3 in.) to spare.

TIP: You can mark the hole used to fasten the buckle for future reference.

Communication with the Dog Collar Device

You should keep an unobstructed line of sight between your navigator and dog collar device to produce the best

communication signal. To achieve the best line-of-sight conditions, you should move to the highest elevation

point in your area (for example, on the top of a hill).

Best

Good

Poor

Dog Collar Device Setup

Table of Contents

Alpha 300