Replacing The Fuse; Servicing The Headlights - Toro DH 220 Operator's Manual

Replacing the Fuse

The electrical system is protected by fuses. They are
located beneath the hood, near the fuel tank (Fig. 24). If a
fuse goes out, check the circuit wiring for a short.
1
5
Figure 24
1. Main/ battery
2. Headlights
3. Interlock, electric clutch,
and cruise control
To replace a fuse, pull up to remove it from the socket.
Push down to insert it.
• Main/ Battery—15 amp
• Headlights—10 amp
• Interlock, electric clutch, and cruise control—10 amp
• Full bag buzzer—5 amp

Servicing the Headlights

Specification: Bulb # 1156, automotive type
Removing the Bulb
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Open the hood.
6. Disconnect the wire connectors from both of the bulb
holder terminals.
7. Rotate the bulb holder 1/4 turn counterclockwise and
remove it from the reflector (Fig. 25).
3
2
4
5
m-4986
4. Full bag buzzer
5. Extra fuse
27
5
3
2
4
Figure 25
1. Bulb holder
2. Reflector
3. Tabs
8. Push and rotate the bulb counterclockwise about 1/4
turn until it stops and remove the bulb from the bulb
holder (Fig. 26).
2
4
3
Figure 26
1. Bulb
2. Metal pins
Installing the Bulb
1. Align the metal pins on the base of the bulb with the
slots in the bulb holder and insert the base into the
holder (Fig. 26).
2. Push and rotate the bulb clockwise until it stops.
3. Align the tabs on the bulb holder (Fig. 25) with the slots
in the reflector.
4. Insert the bulb holder into the reflector and rotate it 1/4
turn clockwise until it stops.
5. Connect the wire connectors to the terminals on the
bulb holder.
5
1
4
1874
4. Slots
5. Terminals
1
2
4
1875
3. Bulb holder
4. Slots