Saw Chain Filing And File Gauges - Husqvarna 385XP EPA I Operator's Manual

RECOMMENDED CUTTING EQUIPMENT FOR CANADA
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of powerhead, bar
and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Length, inch Pitch, inch
18-28 3/8"
18-28 3/8"
Listed ATM is the Oregon designation of Armour Tip Medium hard nose bar.
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding bar, see the
table below.
0,050"/1,3 mm -
0,058"/1,5 mm H42
WARNING! This chain saw model is capable
!
of severe kickback that could result in
serious injuries to the user. Do not operate
this saw unless you have extraordinary
cutting needs and experience and
specialized training for dealing with
kickback. Saws with significantly reduced
kickback potential are available. Always use
the safest saw and cutting equipment
applicable to your cutting need.
Saw chain filing and file gauges
38 –
Canadian
TECHNICAL DATA
Bar
Gauge, inch
0,058
0,058
72LP 72LG 72V
73LP 73LG 73V
Max. nose radius Type
11T Husqvarna H42,
Husqvarna H48,
ATM 1,33"
Husqvarna H81
Chain
Drive link count
68-92
68-92